Quote 31HM45-44 when the equipment file calls for the exact Klixon part shown here. The gallery includes a marked metal housing and a view of the three terminals. Condition on request. Use the photos to identify the offered part, not to assign a rating, prove compatibility or count inventory.
A service request often begins with a compressor number rather than a complete protector number. Ask the equipment owner to identify the approved bill of materials and its revision before treating a photo match as an ordering decision. Sensata describes the 31HM family as hermetic on winding motor protection for three phase applications. That family description does not determine the calibration or mechanical arrangement of this Klixon 31HM motor protector. Keep the exact component reference and the equipment reference in separate fields on the request.
Read the label on the photographed unit and preserve both 45 and 44 in the identifier. When a stock system omits punctuation, retain its searchable alias separately from 31HM45-44. If the old unit is unavailable, record that the match was made from an approved parts list rather than from a physical comparison. That distinction matters if a later inspection reveals a terminal or marking difference.
The terminal side shows three blade features around a round metal face. Compare a three terminal motor protector in the same orientation before calling two units identical. A picture shows placement and visible condition, but it does not determine what each terminal does. If the position or size of a terminal is critical, obtain the approved dimensional information or a sample. Do not infer wiring assignments from the viewing angle or a terminal count.
Document the shape of the can separately from the tab arrangement. A three terminal motor protector may share its housing outline with another configuration. A comparison should identify where the tabs sit relative to the housing and which features will be measured before acceptance. The equipment maker or the responsible engineering reviewer should determine whether a difference is allowable. Purchasing can record the difference without approving it.
Ask for an offered unit photo that shows the complete body marking and a corresponding terminal view. If an inspection sample is required, state whether it is for marking identification, fit review or an evaluation under the equipment owner's approved procedure. A sample ordered to check a Klixon 31HM motor protector for fit is not automatically approved for installation. If a later balance is offered from another lot, repeat any checks required by the purchase and receiving procedures.
Use a receiving checklist with distinct entries for the body mark, physical condition, visible terminal layout and required paperwork. Record whether each item was checked against a photograph, the equipment record or a reference part. If the provided evidence only confirms identity, say so. The stock photos show several devices, but they do not establish the available quantity, the offered condition or whether the lot is uniform. Ask the supplier to state what is available for the actual quote.
Keep an alternate quote line separate from the exact match line. A supplier may be able to identify another Klixon 31HM motor protector, but the reviewer must determine whether the mechanical interface and protection characteristics meet the equipment requirements. If an alternate is accepted for one equipment revision, preserve that limit in the approval record. Do not treat it as an unrestricted cross reference for all motors that use a similar protector.
For a maintenance program, a previous order can help locate the accepted reference without authorizing a new substitution. Check that the equipment revision on the current request matches the one on the previous purchase. If the offered units use another lot or the terminal view is different, record what must be checked again. Keep the original approval, the supplier quote and the receiving result together. The next buyer should be able to tell whether a supplier simply repeated an older item description or actually confirmed the requested marking. Do not record a family level identification as an exact part approval.
No. Use exact part information and the approved equipment documentation for that decision. Do not apply a series range as the setting of one marked unit.
Not on appearance alone. Compare the full ordering reference and required protection behavior as well as the physical layout. Record who can approve a substitution and keep any unresolved questions on the order file.
List each approved equipment reference and state whether the same Klixon 31HM motor protector is authorized for every job. Give the buyer enough information to keep the ordered parts associated with the correct maintenance records at receipt.
Use Request a Quote for 31HM45-44. Include quantity, destination and the exact evidence you need to verify the offered units before purchase.
Explore premium ICs, sensors, and power controls to support your advanced technical requirements.