CSJ-38-CV is the ordering reference for the Klixon CSJ motor protector shown here. One image shows a round housing with a red button. The other shows the terminal face. Condition on request. These photographs help identify the offered configuration, but they do not verify the calibration, the function of individual terminals or the way a machine will behave after a protection event.
Ask the equipment owner what must happen after the protection device operates. In some assemblies, the service instructions require an operator action before the equipment is returned to operation. The approved wiring and control design determine the overall restart behavior. A photo of a red button motor protector cannot tell you whether pressing the button will restart the machine, whether other controls are involved or what checks a technician must perform first.
Sensata's general phenolic motor protector literature describes both automatic and manual reset configurations. Use that distinction to frame the purchase review, not to assign a rating or an exact operating sequence to CSJ-38-CV. If the approved service record calls for a particular reset function, ask for documentation covering the exact reference. Do not treat a different device as an acceptable replacement just because its actuator looks the same. Do not bypass the equipment's protective controls to compare a sample.
Use the photograph with the red button to identify the side that faces the service access point. Then consult the assembly drawing to see where the housing and its actuator are positioned relative to the cover. If access requires a particular opening or clearance, record the requirement in the enquiry. Do not scale the image to estimate button projection or travel. For a red button motor protector, the visibility of the actuator on a loose unit does not establish that a technician can reach it in the assembled equipment.
A sample may help resolve a mechanical question when the drawing does not show the detail needed for comparison. Say whether you want to compare the button position, housing profile or terminal orientation. Do not ask the supplier to certify application fit from the photos alone. Any review of installed access should follow the equipment owner's procedures. If an offered Klixon CSJ motor protector differs from the approved reference, record the difference and ask for an engineering decision before accepting the order.
Hold the device and reference images in the same orientation before comparing visible terminal positions. An apparent difference can come from rotating a photo, so use a common housing feature to orient the images. The terminal face can help identify the proposed part, but it is not a connection diagram. Do not infer contact assignments, operating temperature or the required electrical characteristics of the red button motor protector from its external features.
For CSJ-38-CV, write the full identifier in the manufacturer part number field. Keep the CV ending visible in supplier responses and on the receiving checklist. If a picture does not show a readable mark, ask for the marking on the actual offered unit and identify the equipment record that supports the request. Do not use the number 38 as an electrical setting or as a substitute for the complete ordering reference.
Compare the part reference and visible features against the offer and the approved spare record. Note whether your check was based on an offered photograph, a physical sample or a drawing. If a red button motor protector arrives with a different marking or an unclear terminal face, keep it apart from accepted spares until the buyer resolves the discrepancy. A visual identity check does not confirm how a device operates or how the equipment responds.
For a service program with several equipment revisions, retain the exact part reference with each allocation. If a substitution was approved for one revision only, record that restriction. Do not change the general stock description to imply wider approval. Keeping the quote line, the inspected marking and the equipment reference together makes it easier to confirm what was accepted when a later order is placed.
No. It identifies a visible feature. Ask for the exact documentation and compare it with the approved service procedure before making an application decision.
Request its full number as a separate alternate. Have the responsible reviewer compare the required protection behavior, physical access and terminal arrangement.
Use Request a Quote for CSJ-38-CV. Include quantity, destination, the approved spare reference and any marking, actuator or inspection evidence needed before purchase.
Explore premium ICs, sensors, and power controls to support your advanced technical requirements.